Iv. Live-Voiced Cabs

The cab selections in non-Studio/Direct modes use "live-voiced" cabs which are a mild EQ effect designed to make whatever real cabinet you are using sound more like the cab model selected in the cab. Note: although you can change the selected microphone and there is a gap in audio as you change selections, it has no effect on the tone. These are disabled by selecting "no cab".

These have also been called cab simulation without mic simulation. "Cab simulation" is the wrong name. By itself, it does not come close to the frequency response changes made by real guitar speakers - it is designed to supplement, not replace, a real guitar cabinet (or speaker simulator/IR). Without such, "cab simulation" will sound nothing like a real guitar cabinet, mic'ed or not. It will be very harsh.

Note: simply because some speakers/cabs are marketed towards guitarists or look like a traditional guitar speaker cabinet does not mean their speakers have the frequency response of traditional guitar speakers. They may use full-range speakers, and the tone you get from your Pod through them will likely be harsh if you use a non-"Studio/Direct" output mode, unless you use some strong EQ'ing to roll off the high end frequencies.

I don't like using "live-voiced cabs" even with a real amp and guitar speaker. It seems to drop out some of the high end, leaving the Pod sounding a bit muffled. If I want to do this at all, I'd prefer to do it in an EQ effect where I have more control. Still, you might as well give it a shot to see if you prefer the tone. And don't just try the few cabs you want to sound like. The 1x12 and 2x12 models might give you a thicker tone than the 4x12's - they're not going to magically make your half stack sound like an open back 1x12.

Top of Pod Setup

v. Cab/Mic Simulation

In Studio/Direct output mode only, the cab block is essentially running the signal through an impulse response for that cab/mic combination. This is designed to simulate as if the signal was run through real speakers and mic'ed up with the selected mic model. This is disabled by selecting "no cab".

This is the only true speaker simulation. Use this mode for all "direct" setups as described here to usually get the most natural/standard guitar sound. Everything else may sound incredibly harsh, unless you use an external speaker simulator/IR, because it is not applying true guitar speaker simulation.

Top of Pod Setup

Vi. Bass Boost

The combo output modes apply a bass boost to the live-voiced cabs, designed to compensate for the lower bass response combo amps usually have. So if you dial in a tone for your combo amp but switch to a half/full stack (or vice versa), you can change the output mode and theoretically don't have to re-EQ the low-end response for your patch.

Some people like the combo modes even through a half/full stack, because they have more bass. This kind of defeats the reason there are different combo/stack modes. I'd rather use them like designed, so I can switch rigs without having my bass response thrown too far out of whack and having to dial in my patches again. If I need more bass on a half stack rig, I dial it in on the amp controls or an EQ effect. Or I check that I'm using the "full" amp models. See full vs. pre.

Top of Pod Setup

Date: 2016-01-03; view: 830