Home Random Page


CATEGORIES:

BiologyChemistryConstructionCultureEcologyEconomyElectronicsFinanceGeographyHistoryInformaticsLawMathematicsMechanicsMedicineOtherPedagogyPhilosophyPhysicsPolicyPsychologySociologySportTourism






Grab rail is retained by two bolts (arrowed) on each side


Remove the bolts from the shock absorber upper mountings


4.5a Ease the cowling rearwards off the bike...


Bodywork 8»3



 


 


4.5b... taking care to retain the bushes (arrowed) in the bolt holes


Upper and lower retaining screws (arrowed)


Peg (arrowed) locates in lower edge of fuel tank


 


 

5 Radiator side panels |g>

(R, T, V, W, X and Y models)||
- removal and installation a^

1 Remove the upper and lower retaining screws and their washers (see illustration).

2Pull the rear edge of the panel away from the motorcycle to release the peg on the back of the panel from the grommet on the lower edge of the fuel tank (see illustration).

3Installation is the reverse of removal.

6 Rear view mirrors-

removal and installation

1Lift the cover, where fitted, on the rear view mirror mounting lock nut, slacken the locknut


and unscrew the mirror from the handlebar bracket. Note, on R, T, V, W, X and Y models, the rear view mirror mounts directly onto the front brake master cylinder and the clutch lever; on SW, SX and SY models the mirror mounts onto the rear half of the master cylinder and clutch lever clamps. 2 Installation is the reverse of removal. Sit on the motorcycle and adjust the mirror position before tightening the locknut. Final adjustment can be made by tilting the mirror.

^

Fairing

(SW, SX and SY models)-
removal and installation iS

Removal

1 Disconnect the front turn signal wiring


connectors on each side inside the fairing. Unscrew the nuts securing the turn signal assembly brackets to the fairing frame and withdraw the signal assemblies through the fairing (see illustrations).

2Pull the storage box out of the recess in the right-hand side of the fairing (seeillustration).

3 Remove the screws securing the sides of the fairing to the mounting brackets (see illustration).Pull the lower rear edge of the fairing away from the motorcycle to release the pegs on the back of the fairing from the grommets in the lower edge of the fuel tank (see illustration)

4Disconnect the wiring connector for the sidelight and pull the headlight connector off the back of the headlight unit, then carefully pull the fairing forward and off the motorcycle (see illustration).


 



 


 



Date: 2016-01-14; view: 492


<== previous page | next page ==>
A Unscrew the bolt (arowed)... | A Unscrew the nut (arrowed)
doclecture.net - lectures - 2014-2024 year. Copyright infringement or personal data (0.006 sec.)