Home Random Page


CATEGORIES:

BiologyChemistryConstructionCultureEcologyEconomyElectronicsFinanceGeographyHistoryInformaticsLawMathematicsMechanicsMedicineOtherPedagogyPhilosophyPhysicsPolicyPsychologySociologySportTourism






On SW, SX and SY models remove frame cross-member


 



 


 


A Unscrew the upper .


B .


And lower left-hand sub-frame bolts


Remove the lower rear mounting nut, bolt and spacer (arrowed)


2»8 Engine, clutch and transmission



 


 


A Remove the upper rear mounting nut, bolt and spacer (arrowed)


B Bolts and spacer lengths differ. Upper rear (A), lower rear (B) and front (C)


 



frame on the left-hand side (see illustration). Note:The engine mounting bolts and spacers are of different lengths and must not be interchanged. Keep the spacers on their respective bolts ready for reassembly (see illustration).

28The engine can now be removed from the frame. Check that all relevant wiring, cables and hoses are disconnected and secured well clear, then carefully lower the engine and manoeuvre it out of the side of the frame (see Caution above).

29 With the aid of an assistant lift the engine

Raise engine unit into position with the help of a jack


unit off the jack and lower it carefully onto the work surface, taking care not to break the long fins cast onto the bottom of the oil pan. These fins are there specifically for the engine to stand on and keep it in an upright position.

Installation

30With the aid of an assistant, place the engine unit on top of the jack and block of wood and carefully raise the engine unit into position in the frame (see illustration).Make sure no wires, cables or hoses become

5.31a Install the spacer (arrowed) and the upper rear mounting bolt...


trapped between the engine and the frame.

31Position the spacer for the upper rear mounting bolt between the frame and the engine on the left-hand side and slide the bolt through from the right (see illustration).Fit the nut, tightening it hand-tight only at this stage. Position the spacer for the lower rear mounting bolt between the frame and the engine on the left-hand side and slide the bolt through from the right (see illustration).Fit the nut, tightening It hand-tight only at this stage.

32Position the left-hand sub-frame and install the nuts and bolts and tighten them hand-tight only (see illustrations).

33On SW, SX and SY models, position the front frame crossmember and install the nuts and bolts securing it to the frame, tightening hand-tight only.

34 Position the left and right-hand spacers (R, T, V, W, X and Y models only) for the front mounting bolt between the frame and the engine and slide the bolt through from the right (see illustration).Fit the nut, tightening it hand-tight only at this stage.

35Ensure all parts are correctly aligned, then tighten all the nuts and bolts to the torque settings specified at the beginning of the Chapter starting with the lower rear mounting


 



 


 


5.31b ■ ■. then the spacer (arrowed) and the lower rear mounting bolt





Date: 2016-01-14; view: 700


<== previous page | next page ==>
Operations requiring engine removal | A Loosely assemble the left-hand sub-frame...
doclecture.net - lectures - 2014-2024 year. Copyright infringement or personal data (0.006 sec.)