Drilling for Excavation by Blasting

This reference edition deals with surface rock drilling used for the purpose of excavating rock by means of blasting. Other types of drilling, such as drilling for oil and water, mineral exploration, and grouting are excluded.

The reader is given a brief explanation of the various prevailing drilling methods, as well as an introduction to blasting technique, and the interrelation of drilling and blasting. Also discussed are the main parameters involved when planning and exe­cuting blasthole drilling at quarries, open pit mines and various types of civil engineering projects.

The range of Atlas Copco products, with references to the Atlas Copco internet home pages, are presented and discussed by comparing their suitability and expected productivity related to various applications. Updated case stories from different worksites in the world should prove interesting and beneficial, when planning and selecting methods and equipment for blasthole drilling applications.

Blastholes have certain unique and important characteristics. These are: hole diameter, hole depth, direction and straightness. Drilling produces a circular hole n the rock, whose strength must be overcome by the drilling tool. Depending on rock properties, there are several ways to accomplish this, as shown in the following article.

Rotary Drilling

Rotary drilling can be subdivided into rotary cutting and rotary crushing.

Rotary cuttingcreates the hole by shear forces, breaking the rock's ten sile strength. The drillbit isfurnished with cutter inserts of hard metal alloys and the energy for reaking rock is provided by rotation torque in the drillrod. This technique is limited to rock with low tensile strength, such as salt, silt, and soft limestone not containing abrasive quartz minerals.

Rotary crushingbreaks the rock by high point load, accomplished by a toothed drillbit, which is pushed downwards with high force. The bit, being of tricone roller type fitted with tungsten carbide buttons, is simultaneously rotated, and drill cuttings are removed from the hole bottom by blowing compressed air through the bit.

Drillrigs used for rotary drilling are large and heavy. The downwards thrust is achieved by utilizing the weight of the drillrig itself, and the rotation, via a hydraulic or electric motor, applied at the end of the drill pipe. Common hole diameters range from 8 to 17.5 in (200-440 mm) and, because adding the heavy drill pipes is cumbersome, most blasthole drillrigs use long masts and pipes to accommodate single-pass drilling of maximum 20 m (65 ft). Electric power is usually chosen for the large rigs, whereas smaller rigs are often powered by diesel engines.

Rotation rates vary from 50 to 120 rev/min, and the weight applied to the bit varies from 0.5 t/in of bit diameter in soft rock, to as much as 4 t/in of bit diameter in hard rock.

Recent technical advances include: improved operator cab comfort; automatic control and adjustment of optimum feed force and rotation speed to prevailing geology and bit type and diameter; and incorporation of the latest technology in electric and hydraulic drive systems.

Rotary drilling, which is still the dominant method in large open pits, has limitations in that the rigs are not suited to drilling holes off the vertical line. As blasting theories and practice have proved, it is generally beneficial to design, drill and blast the bench slopes at an angle of approximately 18 degrees off vertical.

Many rotary rig masts have pinning capabilities permitting drilling at angles as much as 30 degrees out of the vertical. However, the inclined hole drilling capabilities in rotary drilling are limited by the heavy feed force required, since part of this force is directed backwards. This causes rig stability problems, reduced penetration, and shorter life of drilling consumables. Consequently, most blast hole drilling using rotary drillrigs is for vertical holes.

Date: 2015-12-24; view: 732